Most Popular Parts
These are the most commonly purchased repair parts for PCGS920EEJ3ES.
-
(15)
The flat style oven igniter is used to ignite the gas to light the oven burner in your range. If your oven is not heating, check the igniter to make sure it is glowing. If the igniter is glowing and your oven is not heating, then your igniter is not strong enough to heat the oven and you will need to replace it. When replacing the igniter please be very careful not to touch the black element part of the igniter as it is very fragile. The part measures approximately 3-3/4" in length and the amperage range is 3.3 to 3.6. The kit comes with a mounting bracket and a wire connector with a plug. *Please note: the connector plug might need to be removed and spliced to the range wiring using porcelain wire nuts. This is a genuine OEM part.
-
(3)
The oven door bumper is used to protect the exterior of the oven when the door is closed. By installing the door bumpers, it will prevent the drawer door from rubbing against the cabinet. If one breaks or goes missing you will need to replace the bumper. This part is black in color, made of rubber, and is sold individually. This is a genuine OEM part.
-
(7)
The temperature sensor detects the temperature within the oven cavity. If your oven is too hot, not heating evenly, or has little to no heat when baking, you may need to replace the temperature sensor. The sensor is usually located in the back of the oven. This is a genuine OEM part. Please make sure to disconnect the power to your range before starting your repair.
-
(3)
This surface burner head is for ranges.
Surface burner head distributes the gas through holes or slots to create an even flame across the cooking area.
Shut off the gas supply and unplug the range before installing this part. Wear work gloves to protect your hands.
-
(3)
The burner cap sits on top of the burner base and acts as a cover for the burner head. It helps protect the burner head from spills and helps spread the burner flame for even cooking. It is black in color and just over 3 inches in diameter. If your old burner cap is damaged or missing, this is the part that will replace it. This is an OEM part sourced directly from the manufacturer and is sold individually.
-
(2)
This part is the replacement oven burner igniter, broil igniter, or glow bar igniter for your cooktop or range. It is designed to ignite the fuel from the fuel lines and light the broil burner. If your broil burner will not ignite, it is a good indication that the burner igniter is burned out or damaged. Be sure to shut off the power and gas to the range before you begin to repair this part. This part is sold individually and is an OEM part from the manufacturer.