Most Popular Parts
These are the most commonly purchased repair parts for RBS245PDS16.
-
(11)
This bake element has push-on terminals and is located on the bottom of the oven. It provides heat for baking. If your oven is too hot, not heating evenly, the element is not heating, or there is little to no heat when baking, you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.
-
(2)
The temperature sensor, also known as an oven probe, detects the temperature within the oven cavity. This temperature sensor is a genuine OEM part. If your oven is too hot, not heating evenly, has little to no heat when baking, or is flashing F3/F4 error messages on your control board, you may need to replace the temperature sensor. Please make sure to disconnect the power to your range before starting your repair.
-
(2)
This broil element is for ranges.
Broil element is at the top of the oven and supplies the heat for broiling.
Disconnect electrical power to the range before installing this part. Wear work gloves to protect your hands.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
This screw is half an inch long. It is made of metal and is intended for use with ranges, refrigerators, and washing machines.
-
(1)
This 120-130 volt 15-watt light bulb is used to illuminate the interior part of the oven cavity when the door is open or when the light switch is turned on. The bulb has a small screw base and is approximately 2 inches long. If the light bulb does not come on when the door is open or the switch is turned on you may need to replace the bulb. If the bulb has been replaced and still not working you may want to check the light socket. It is recommend to wear gloves while replacing the bulb in case the existing bulb breaks when you try to remove it. This is a genuine OEM part and is sold individually.