Most Popular Parts
These are the most commonly purchased repair parts for RBS305PDZ1.
-
(4)
This single oven rack is used to provide a durable surface for your cookware inside the oven for baking/broiling. The oven rack measures approximately 24.76” x 15.78”, is made of metal and is chrome in color. This oven rack is a genuine OEM part and is sold individually.
-
(11)
This bake element has push-on terminals and is located on the bottom of the oven. It provides heat for baking. If your oven is too hot, not heating evenly, the element is not heating, or there is little to no heat when baking, you may need to replace your bake element. You can use a multi meter to test the bake element for electrical continuity to see if you need to replace it. This is a genuine OEM part. Please remember to disconnect the power to the range before starting your repair.
-
(7)
The inner door glass forms a see-through heat barrier inside the oven door. When your oven door is closed, this glass is the innermost piece of glass. The glass measures 10” x 20”. This includes the glass only. It is recommended to wait until the glass is cool to touch before starting the repair. Make sure to wear gloves to protect your hands in case the glass breaks while removing it from the door. This is a genuine OEM part.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
This part is the replacement door gasket for your oven. It is made of gray rubber and is sold individually. The door gasket runs along the circumference of the oven door and creates a seal that insulates the oven and keeps heat in. If your oven will not heat up properly, or if you notice that the door gasket has become loose or worn, it may need to be replaced. To replace the door gasket, you will need to remove the retaining bracket at the bottom of the oven door, then carefully pull the gasket away from the front of the oven cavity. Then, push the new gasket inside the groove on the outside of the oven cavity, securing it with the arrowhead fasteners that are built in to the oven cavity. This is an OEM part from the manufacturer.
-
This broil element is found on the roof of the oven.