Most Popular Parts
These are the most commonly purchased repair parts for RC8300XPH.
-
(4)
This newer-style terminal block kit includes two metal brackets, two pre-crimped wires with terminals, two ceramic wire nuts, a heat shrinking tube, and a mounting screw. This part is used to connect the wire harness to the surface burner element. If your element will not heat at all, or if it is not heating properly, it is likely an issue with the terminal block and it will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power supply before starting your repair.
-
(7)
This six-inch chrome drip bowl is intended for use with rolled terminal-style plug in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
This eight-inch chrome drip bowl is intended for use with rolled terminal style plug-in surface element units. The drip bowl sits under the burner to catch anything that may spill over to make cleaning up spills quick. This is a genuine OEM part and is sold individually.
-
This 8” plug in style surface burner element provides heat to the cooking surface of your range. The burner element has looped terminal ends, 2600 watts, and a 5-turn. If the burner element is not heating it could be the element or the burner switch. You can use a multimeter to test the element or the switch for continuity. This is a genuine OEM part; the manufacturer recommends replacing the burner receptacle when you replace the surface burner element. Please make sure the power has been disconnected and the element is turned off and had time to cool before starting your repair. This part is sold individually.
-
(3)
This standard Y-frame 6” surface element is a genuine OEM part that supplies heat to the cooking surface on your range. It has four turns, a black center medallion, looped terminal ends and carries 15000 tts. If your element is not heating, you may need to replace it. Please be sure to disconnect the power to your range before starting your repair. The manufacturer suggests replacing the receptacle at the same time.
-
Sold individually.