Most Popular Parts
These are the most commonly purchased repair parts for REM77BLB0.
-
(2)
This 40-watt light bulb has a standard screw-in base and is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.
-
(7)
This is an oven bulb lens cover. It is made of glass and is approximately 3 inches in diameter. The lens cover protects the light bulb from being damaged. The main reason to replace the light lens cover is if it is cracked, damaged, or missing. Make sure the lens cover is cool to the touch before you begin this repair. To remove the lens cover, simply turn it counter clockwise until you can remove it. Replace it with a new cover and turn it clockwise to lock it into place. This is an OEM part sourced from the manufacturer, and it is sold individually.
-
(3)
If your oven is too hot, the element will not heat, or there is little to no heat when baking, you may need to replace your bake element. The 2100-watt element is located on the bottom of the oven and it supplies heat while baking. When replacing the element, make sure to hold the wires forward so the wires do not fall back through the rear of the oven. Please remember to disconnect the power to your oven before starting the repair. This bake element is a genuine OEM part.
-
(1)
This terminal block kit (also called terminal boards or strips) provides a convenient means of connecting individual electrical wires. This kit includes mounting screws and hex nuts and can be used with dryers and ranges. This kit allows you to attach the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to operate properly. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.
-
Also known as a temperature sensor. This part is used to detect the temperature within the oven cavity.
**The following instructions only apply if the connector piece is different than the original.**
Prior to cutting the leads, please check the length of the wire you will need.
1. Cut the leads on your original sensor and the replacement sensor. Be sure to leave enough length to strip and splice the new probe and original connector together.
2. Strip the insulation, or wire cover, back approximately 1/4 inches on the new probe and original connector.
3. Twist the ends of your new probe and original connector together
4. Use a wire nut, or another high heat fastener to cover your exposed wires.
5. Install your new oven probe and re assembly your oven.
-
The broil element is located on the roof of the oven cavity to supply heat for broiling. The element measures approximately 13 1/2-inch wide, 19-inch long and is 3000 watts. If the broil element is no longer heating or it has shorted out, you will need to replace your broil element. Please remember to disconnect the power to the oven before starting your repair. This is a genuine OEM part.