Most Popular Parts
These are the most commonly purchased repair parts for RT14DMYAL01.
-
(27)
This 8-cube ice maker is used to help produce ice for your refrigerator. The ice maker receives water from the water inlet valve and will freeze the water until ice cubes are formed. Once the water has been frozen the ice cubes will be ejected from the mold into the ice bucket and will refill with water to repeat the process until the ice bucket is full. This ice maker does not include the bail or shut off arm. You can reuse the arms for your old ice maker or you can also order them separately if required. It does come complete with flat and round plug wiring harness, the mounting hardware, and the instructions. The harness can be reused. This ice maker will not fit refrigerators that have the ice auger mounted on the door. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.
-
(7)
Door switch turns the light off when you close the door.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(4)
The single water inlet valve is used to supply water to the water dispenser and the ice maker. The valve is 60Hz 120 Volts and 35 watts. If your ice maker isn’t producing ice or the water dispenser not dispensing water, the solenoid might have gone bad and will need to be replaced. This valve includes 1/4” tubing and a plastic union. This is a genuine OEM part. Please remember to disconnect the power and the water supply to the refrigerator before starting the repair.
-
The refrigerator door shelf bar is an attachment for your refrigerator door. The shelf bar attaches to the end caps inside of the refrigerator door to hold items on the door shelves. The shelf may need to be replaced if it is warped or broken. The shelf measures approximately 22 inches long and is white in color.
-
(3)
The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.