Most Popular Parts
These are the most commonly purchased repair parts for RT18BMXVW05.
-
(7)
Door switch turns the light off when you close the door.
-
(3)
This is a 6 piece kit.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(4)
This 120 volt, 60Hz defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. If the refrigerator is too warm, freezer section too warm or freezer not defrosting you might need to replace the defrost timer. This is a genuine OEM part. Disconnect the power to the refrigerator before starting the repair.
-
(3)
The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.
-
(1)
The evaporator fan motor is in the back of the freezer section and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated from the freezer section to the fresh food section. It is suggested to replace the thermistor when replacing the evaporator fan. This kit comes with two mounting grommets, two sleeves (not to be used on porcelain models), two #8 mounting screws, and a push-on fan blade. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting your repair.