Most Popular Parts
These are the most commonly purchased repair parts for SDG5401AWQ.
-
This part is located between the drum support rollers and idler pulley in your dryer to help prevent the parts from bumping up against the brackets they are attached to. If your dryer has a burning smell, is noisy, or will not tumble, you may need to replace the thrust washer. The washer is 3/4 inches in diameter and a is genuine OEM part. It is recommended to disconnect the power to your dryer before you start your repair.
-
(2)
This 1/4 horsepower gas or electric clothes dryer motor carries 120 volts, 60 Hz, and 5.5 amps. It also performs 1725 revolutions per minute. This motor is used for some gas and some electric clothes dryers.
-
The retaining clip goes onto the end of the roller axle and holds the rear wheel onto the axle. If the ring is broken, damaged, making noises, or will not tumble, you will need to replace it. This is a genuine OEM part and is sold individually.
-
(1)
Part may differ in appearance, but functions same as original part.
-
This arm is what attaches to the idler pulley wheel.
-
(1)
This two-inch-wide idler pulley wheel is black in color and is made of plastic. This pulley wheel comes with its own metallic bearing in its center. This part helps maintains the correct tension on the drive belt to rotate the drum. The drum will not spin if the idler pulley fails to put the correct amount of tension on the belt. It is recommended to disconnect the power to your dryer before you start your repair.