General Electric Trash Compactor UCG1600L0BB
Repairing your UCG1600L0BB General Electric Trash Compactor is simple with official replacement parts made to fit your model. View a selection of popular parts, or review parts lists for each of the
UCG1600L0BB model diagrams below. Trust us to help you find the part you need and get your
UCG1600L0BB General Electric Trash Compactor running again.
Diagrams for General Electric UCG1600L0BB Trash Compactor
There are 6 diagrams for UCG1600L0BB. Click on the diagram where you think your part is located.
Most Popular UCG1600L0BB Parts
These are the most commonly purchased repair parts for UCG1600L0BB.
-
(1)
The power nut is intended for use with trash compactors. The power nut attaches to the side of the ram where it is threaded. When the power screw rotates, it feeds through the power nut which pulls the ram down to compress the trash. If your trash compactor does not stop at the end of the compacting cycle or the ram gets stuck, you may need to replace this part. The power nut is made from plastic and measures approximately 3” long. Please remember to disconnect the power to the trash compactor before starting your repair. This is a genuine OEM part.
-
(1)
The drawer roller attaches to the bottom of the drawer and allows the drawer to roll in and out.
-
(1)
This part reverses the motor direction when the trach compactor has reached the top of the drawer. If the cycle is not being completed properly, shut off, or makes loud noises, the top limit directional switch may need to be tested by using a multimeter to test the continuity. If there is no electrical path in the switch, it will need to be replaced.
-
(1)
-
The white plastic compactor bags are used to hold the trash until it is ready for disposal. The bags come in a pack of 15. This is a genuine OEM part.
-
