Most Popular Parts
These are the most commonly purchased repair parts for VISR309JTAAA.
-
This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.
-
(10)
This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.
-
(1)
This knob accepts a D-shaped shaft. Sold individually.
-
(13)
This plastic dual action agitator is white in color. It is approximately eighteen inches tall with a base diameter of about 12-1/4 inches. The agitator pivots back and forth, moving the clothes from the top to the bottom of the tub, through the detergent and water to wash them. If the agitator becomes damaged or will not agitate, you may need to replace the part. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(2)
The tub seal helps prevent any leaking around the transmission of your washer outer tub. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. It is suggested to have it installed by a qualified technician because the seal can be difficult to replace. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(3)
This is a washing machine agitator coupling kit also known as an agitator drive belt. It connects the transmission drive shaft to the agitator base. It includes the couple, gasket, and bolt. If the teeth on the coupler is worn out it will cause the agitator not to turn and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power before starting your repair.