Most Popular Parts
These are the most commonly purchased repair parts for VVSR1030H5WO.
-
This part is used to support the tub and keep it in the center of the cabinet to reduce vibration. If your washer is making loud noises, or shakes or moves, one or more of the straps may have broken. It is recommended to replace all 4 tub dampening straps at the same time. This part is sold individually.
-
(10)
This corrugated drain hose carries the drain water from the washer to the house drain. It is black in color, measures 57-inches long, and both ends of the drain hose can be bent. If your drain hose becomes damaged or cracked, it will cause water to leak on the floor during the wash cycle and you will need to replace the hose. This is a genuine OEM part. Please make sure you shut off the water supply and disconnect the power to the washer before starting your repair. Note: Clip is not included.
-
(5)
This part is a replacement control knob for your washer. The control knob allows you to select the desired setting for your wash cycle. If your washer will not start or the timer will not advance, you may need to replace the control knob. Occasionally the control knob will become worn, and when this happens the control knob dial will not turn, and you will not be able to select the appropriate setting. If your control knob is worn, broken, or missing, you will need to replace it. The control knob is made of white plastic and is approximately 2 inches in diameter. The control knob is sold separately from the control knob dial, so be sure to confirm which part you need to complete your repair.
-
(2)
The tub seal helps prevent any leaking around the transmission of your washer outer tub. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. It is suggested to have it installed by a qualified technician because the seal can be difficult to replace. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.
-
(3)
This knob accepts a D-shaped shaft.
-
(1)
This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you may need to replace the tub bearing. This bearing is made of metal, and is approximately 3 inches wide and 2 inches tall.