Most Popular Parts
These are the most commonly purchased repair parts for WFW8500SR00.
-
(12)
This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period. It has two ports for water to pass through: a large one, and a smaller one. If your washer will not drain, is noisy, leaking, or pumps but will not spin you may need to replace the pump. This is a genuine OEM part. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair. This pump also comes with a removable filter.
-
(1)
Also known as a door boot seal.This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle.
-
(1)
Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.
-
(3)
This part ensures that your door stays locked while the machine is running.
-
(2)
This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature or amount of water needed.
-
(1)
This is a replacement tub-to-pump hose for your washer. This hose runs from the bottom of the tub to the water pump, and is used to transport water. The hose can develop a hole, and when this happens you will notice water leaking onto the floor. The tub-to-pump hose is found below the washer tub. To disconnect the hose, you will need to release the clamps that hold it in place with a pair of pliers. When you replace the tub hose, you will need to transfer the ball, air chamber, and clamps from the old pump to the new one. To do this, you will need a set of wire cutters and a new zip tie to replace the one you will need to cut.