Magic Chef Dryer YE20HN3C Sections

There are 10 diagrams for YE20HN3C. Click on the diagram where you think your part is located.

CABINET (REV. E)

CONTROL PANEL (REV. A - D)

CONTROL PANEL (REV. E)

CYLINDER & DRIVE (REV. A - D)

DOOR (REV. E)

EXTERIOR (REV. A - D)

HEATER (REV. A - D)

HEATER (REV. E)

MOTOR & DRIVE (REV. E)

TUMBLER (REV. E)

Most Popular Parts

These are the most commonly purchased repair parts for YE20HN3C.

Multi Rib Belt - 92-1/4"

$16.00

In Stock

(42)

This dryer drum belt has four ridges, three grooves, 1/4-inch wide and 92 1/4-inch long. The belt helps rotate the drum. If the drum does not rotate and you can still hear the motor running, the belt may have broken and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your dryer before starting the repair.
Screw, 8/18 x 3/8

$7.40

In Stock

This screw is sold individually.
Door Catch Kit

$27.00

In Stock

The door catch helps keep the door closed while the machine is running. If your dryer will not start or the door will not close you may need to replace the door catch. This is a genuine OEM part and includes both the male (strike) and female (catch) pieces. Please remember to disconnect the power to your dryer before you start the repair.
Lint Filter

$48.87

In Stock

(2)

The lint filter is used to collect lint and debris as it passes through the dryer vent. It is recommended to clean the lint filter before every load. If your dryer takes too long to dry you may need to replace the filter. This lint filter screen has two side guides on either of the screen. One measures 3/8 of an inch wide, while the other measures 5/8 of an inch wide. This is a genuine OEM part.
Lint Duct Housing

$95.76

In Stock

(1)

Does not include the seal
Heating Element Kit - 240V 4750W

$60.87

In Stock

(2)

This heating element assembly includes the high limit thermostat (L240-80F). The 240-volt 4750-watt, heating element produces heat for drying clothes inside your dryer. If your dryer takes too long to dry or has no heat, you should check for a blown thermal cut out or a thermal fuse. Some heating elements will often have a break in the coil element and will need to be replaced. The element measures approximately 10” L x 3.5” W and the thermostat measures 2” L x 1 1/2” W. Please remember to disconnect the power to the dryer before starting the repair. This is a genuine OEM part.