Most Popular Parts
These are the most commonly purchased repair parts for ZISB42EMB.
-
(17)
This ice maker assembly is used to make ice in your refrigerator. The ice maker receives water from the water inlet valve and will freeze until ice cubes are formed. Once the water has been frozen the cubes will be ejected from the mold into the ice bucket. The ice maker will continue the process until the ice bucket has reached the limit. If your ice maker is not making ice you may need to replace this part. This kit includes the fill cup, 4-pin wire harness adapter, and a tube. Disconnect the power and water supply before starting your repair. This ice maker is a genuine OEM part.
-
(4)
The refrigerator light switch turns the interior light off and on when you open or close the refrigerator door. The light switch also prevents the front dispenser from working if the refrigerator door is opened. If the switch has shorted out or the light bulb is not turning on when the door is open, you may need to replace the switch. This switch is white in color and measures approximately 1 1/2” L x 1 1/4” W. This is a genuine OEM part. Please remember to disconnect the power to the refrigerator before starting the repair.
-
(2)
This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer come with the part.
-
(1)
This valve comes with 1/4" compression inlet.
NOTE: This part comes with new quick connections. To install - cut retaining nuts off of existing plastic water lines and gently push them into new valve. To remove - depress ring that the tube slides into.
-
The defrost timer acts like a clock, continually advances and alternates between activating the cooling cycle and the defrost heater. This 120V 60Hz defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange. If your refrigerator is too warm, freezer section is too warm, freezer is not defrosting, or leaking, you may need to replace the defrost timer. This is a genuine OEM part. Please remember to disconnect the power before starting the repair.
-
This kit includes 1 cube solenoid, 1 armature, 2 tooth washers and 2 1/4 hex head screws.