Dryer Sensors

Temperature Sensor

3 Reviews

Part Number: WR55X10025

The temperature sensor, also known as a thermistor, helps detect the temperature inside the refrigerator and sends the information to the control board. If your refrigerator is too warm or not cooling properly, you may need to replace the temperature sensor. This is a genuine OEM part. Please make sure to disconnect the power to the refrigerator before starting your repair.

Thermostat, Internal-Bias

2 Reviews

Part Number: WP8577274

This thermostat may differ in appearance, but functions the same as the original part. This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating.

Moisture Sensor

2 Reviews

Part Number: WP3387223

This is the moisture sensor for your dryer. It helps detect the amount of moisture in your clothes during the dryer cycle. If you notice your clothes are still wet after an automatic dryer cycle is done, you may need to replace the sensor. You will find the moisture sensor behind the lint screen. Be sure to disconnect the power source from the dryer before you begin this repair. Note: Some model's require two sensors, please order quantity needed. Sensor only, harness is not included. This part is sold individually.

Moisture Sensor

Part Number: 6500EL3001A

The moisture sensor, also known as a humidity sensor, works in conjunction with your dryer by helping determine the amount of moisture in the drum to reduce overdrying. If the timer doesn’t advance correctly, it is suggested to check the moisture sensor bar for damage. A damaged sensor can cause the automatic drying cycle to not work properly and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting this repair.

Dryer Radiant Flame Sensor

Part Number: WP338906

This part senses if the igniter is hot enough to ignite the flame for heat, allowing the gas valve to open. The sensor is three inches long and is used for many gas clothes dryers. If your dryer is not creating any heat, taking too long to dry or shuts off too soon, you may need to replace the flame sensor. This is a genuine OEM part and is made of both plastic and metal. Please remember to disconnect power to your dryer before starting your repair.

Inlet Control Thermostat

1 Review

Part Number: WE4M398

This part is located on the housing for the heating element.

Control Thermistor

1 Review

Part Number: 134587700

This part controls the temperature of the inside of the dryer drum and prevents the dryer from overheating. This part is located in the blower housing.

Moisture Sensor

1 Review

Part Number: 134786100

Temperature Sensor

1 Review

Part Number: WPW10467289

This part regulates the temperature of the water in the tub. The sensor is located in the heating element.

Flame Sensor

Part Number: 5303281135

This part senses the flame for heat allowing the gas valve to open.