General Electric Washer Seals and Gaskets

Upper Drum Glide

2 Reviews

Part Number: 5303937139

The upper drum felt glide kit helps to support the front drum as it rotates smoothly and quietly while operating. This kit includes three glides with the adhesive. If your dryer won’t tumble or is noisy, the glide could be worn down causing you to hear a metal on metal noise and will need to be replaced. The drum glide is a genuine OEM part and sold individually. Please remember to disconnect the power to the dryer before starting your repair.

Tub Seal

2 Reviews

Part Number: WH02X10383

The tub seal helps prevent any leaking around the transmission of your washer outer tub. If your washer is leaking you may need to replace the seal. The tub seal is located on the bottom of the outer tub, in the center where the transmission comes through to connect to the agitator. This is a genuine OEM part. It is suggested to have it installed by a qualified technician because the seal can be difficult to replace. Please remember to shut off the water supply and disconnect the power to the washer before starting your repair.

Front Upper Felt Seal with Adhesive

Part Number: 5303937182

The upper felt seal for your dryer is attached to the top edge of the drum support area, and is held there by a high temperature adhesive. It creates a seal where the dryer door opens and closes, so that heat remains in the dryer while it tumbles. If your old upper felt seal is coming apart, you notice that hot air is leaking out the dryer door, or your clothes are taking too long to dry, you may need to replace the seal. When you order this part, it comes with the upper felt seal, as well as the required high-temperature adhesive.

Washer Door Boot

1 Review

Part Number: WH08X23479

The door boot forms a seal between the wash tub and the door, preventing leaks.

Door Boot Seal

Part Number: WH08X10036

Also known as Bellow. The part may differ in appearance but functions same as original.

Tub Seal

Part Number: WH08X24594

The tub seal is manufactured to create a watertight seal between the tub and the inner spin basket. Your seal will wear over time causing the rubber to dry out and crack, breaking the seal in your washer. You may need to replace this part if you notice leaking in your appliance. This part is about 2.75 inches in diameter, is made of rubber, and is black in color.

Bellow - Gray

Part Number: WH08X10064

This part is also called the Door Boot Seal. It's the main seal between the front bulkhead and the outer tub.

TUB SEAL

Part Number: WH02X10362

GASKET DOOR (NON-STEAM)

Part Number: WH08X10038

GASKET MAIN

Part Number: WH08X22620