Gibson Refrigerator Switches

Refrigerator Door Switch

7 Reviews

Part Number: W11384469

Door switch turns the light off when you close the door.

Run Capacitor

1 Review

Part Number: 5304464438

The run capacitor, with new crimp wire connectors, is attached to the compressor and is 250 volts. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is to warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Door Light Switch

2 Reviews

Part Number: 297243800

This is a switch for your refrigerator, but you may also know it as a door switch or a plunger light switch. This part turns your appliance light on and off as the door is opened and closed. If your current light does not turn on, it will need to be replaced. To make this repair you will need a Phillips head screwdriver, a putty knife, and a flat head screwdriver.

Run Capacitor

Part Number: 218909912

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

SWITCH

Part Number: 216822900

This part turns the light on/off as the door opens and closes.

Refrigerator Compressor Start Relay Kit

Part Number: 5304491941

Compressor start relay kit is an original equipment manufacturer (OEM) part that fits some Kenmore, Frigidaire, Electrolux, Crosley, Gibson and White-Westinghouse refrigerators. It also fits some Kenmore, Frigidaire and Gibson upright freezers. Compressor start relay kit includes the compressor start relay, run capacitor, wire harness adapter, 2 wire terminals, 2 wire connectors, 2 pieces of wire connection shrink tubing, the wire retaining clip and kit instructions sheet. Clarification of instructions: Kit 5304491941 now uses a wire harness with white wires; attach the red compressor power wire to the wire harness adapter's white wire that plugs into the start device terminal at the outside edge of the start device. Replaces original refrigerator and freezer compressor start relay part numbers 216649316, 218721119, 241524601, 241524605 and 5304468029. Fits some refrigerators in the following series: Kenmore and Kenmore Elite 253; Frigidaire FRS, FRT, FRX, FSC, GLH, GLR, GS2, NGS, PHS, PLH and PLRS; Electrolux E23; Crosley CRSE; Gibson GRS and GRT; and White-Westinghouse WRS and WRT. Also fits some upright freezers in these series: Kenmore 253; Frigidaire FFU; and Gibson GFU.

Door Light Switch

Part Number: 241554901

Light Switch

Part Number: 240505801

This is the replacement light switch for your refrigerator. It is white in color and is approximately 2inches long and 1 inch wide. If the light is not working or stays on, you may need to replace the switch. It is an OEM part, directly from the manufacturer. Be sure to disconnect the refrigerator from the power source before you begin this repair. To remove the switch, simply use a flathead screwdriver to pop the switch out from the refrigerator wall, then disconnect the wires. Reconnect the wires to the new switch and snap it into place to complete your repair.

Compressor Start Relay

Part Number: 216594300

The compressor start relay attaches to the compressor to help start the compressor motor and then shuts off as soon as the motor gets up to speed. The relay is black in color and measures approximately 1”. If your refrigerator is not running you may need to replace the relay. You can use a multimeter to check the continuity. The overload is not included with the start relay. The overload must be ordered separately. Please remember to disconnect the power before starting your repair. This is a genuine OEM compressor start relay.

Door/Light Switch

Part Number: 5309918806

This part turns the light on/off as the door opens and closes.