International Dryer Hardware

Retaining Ring

Part Number: WP9703438

The retaining clip goes onto the end of the roller axle and holds the drum roller on to the axle. If the ring is broken or damaged, you will need to replace it. This is a genuine OEM part and is sold individually.

Drum Roller Shaft Washer

Part Number: WP312535

This roller shaft washer is just under an inch in diameter and is used for some Whirlpool brand clothes dryers. It is located on the drum support roller shaft. If your dryer is noisy or will not tumble, you may need to replace the roller shaft washer. This is a genuine OEM part. Please remember to disconnect the power supply to your dryer before you start your repair. Sold individually.

Idler Pulley Shaft Washer

Part Number: WPY312527

This idler pulley shaft washer is used with many clothes dryers and is located between the idler pulley and the bracket. If the idler shaft washer is worn it will cause the washer to rub against the e-clip and bracket which will cause a squeaky noise and will need to be replaced. This part is sold individually and there are two required for each roller. The idler shaft washer is less than an inch long, and it is black in color. Please remember to disconnect the power to your dryer before starting the repair.

Screw, 8/18 x 3/8

Part Number: WP90767

This screw is sold individually.

Spring Retaining Clip

Part Number: WP22001650

This spring retaining clip is used to hold the front panel onto the top of the washer. If your front panel is loose you might need to replace the clip. The clip is made entirely of metal and is used for some washing machines. This part is not quite an inch long and is sold individually. This is a genuine OEM part.

Blower Wheel Clamp

Part Number: WP312967

The blower wheel clamp is used to hold the blower wheel to the motor shaft. The clamp is less than an inch long and is used with your dryer. If your blower wheel is loose or making a noise while operating, you may need to replace the clamp. This is a genuine OEM part. Please remember to disconnect the power to the dryer before starting your repair.

Idler Shaft Retaining Ring

Part Number: WP354987

This idler shaft retaining ring is well under an inch long and is made of metal.

Roller Shaft Hex Nut

Part Number: WP33001443

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

Screw

Part Number: WPY014874

Sold Individually.

Idler Bracket Spacer

Part Number: WPW10116756