International Washer Hardware

Cover Screw

Part Number: WP308685

Sold individually.

Hose Clamp

Part Number: WP596669

This hose clamp expands from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag washing machines to secure the end of the drain hose to the pump drain port. Please make sure to disconnect the power to your washer before you start your repair. This hose clamp is a genuine OEM part and is sold individually.

Screw, 8/18 x 3/8

Part Number: WP90767

This screw is sold individually.

Spring Retaining Clip

Part Number: WP22001650

This spring retaining clip is used to hold the front panel onto the top of the washer. If your front panel is loose you might need to replace the clip. The clip is made entirely of metal and is used for some washing machines. This part is not quite an inch long and is sold individually. This is a genuine OEM part.

Hose Clamp

Part Number: WP285655

This single hose clamp is used to hold the water hose in place on the pump, to avoid the hose or pump from leaking water. If you notice your washer leaking you may need to replace the clamp. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Tension Springs -Set of 2

Part Number: 202718

This is a set of 2 tension springs.

Glide and Spring Kit

1 Review

Part Number: 205000

This glide and spring kit contains two three inch springs, four one inch square glides, and two tubes springs. This kit replaces older style round roller glides.

BOLT

Part Number: W10175938

Screw

Part Number: WPY014874

Sold Individually.

Center Seal Retaining Washer

Part Number: WPY015666

This center seal retaining washer is a little over an inch in diameter. It is made of metal.