Kenmore Dishwasher Hardware

Heating Element Brass Nut

2 Reviews

Part Number: 154106202

The heating element nut is used to install and secure the heating element in your dishwasher. If your dishwasher is leaking you may need to replace the nut. The manufacturer suggests replacing replace both nuts at the same time. This heating element nut is a genuine OEM part and is sold individually.

Wash Arm Retainer Nut

7 Reviews

Part Number: WP9742945

Use this part to secure the lower spray arm of your dishwasher.

Retainer Clip - Black

1 Review

Part Number: WPW10503548

This part is used to hold the access panel in place. Sold individually.

CLIP

Part Number: W10919676

Rubber Washer

Part Number: WP717273

The black heating element washer goes between the heating element and the dishwasher tub to form a seal where the element attaches to prevent water from leaking during its cycle. If the washer goes bad it will cause water to leak out on to the floor. This part is made of rubber, measures approximately 1” in diameter and is sold individually. This is a genuine OEM part.

Retainer Clip - White

2 Reviews

Part Number: WPW10503549

This part is used to hold the access panel in place. Sold individually.

Kickplate Mounting Screw

Part Number: 154754801

Sold individually.

Torx Screw

Part Number: WP3368921

7-18 x 3/4" - sold individually.

Grommet

Part Number: WPW10538166

Screw - 10-16 x 1

Part Number: WP3387230

This screw is sold individually.