10693391 Kenmore Refrigerator Parts List

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Cycling thermostat (thermostat for modular icemaker, with new clips)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Screw

Sold individually.

Freezer door gasket

This door gasket is used to seal the freezer door when closed.

Defrost timer kit (defrost timer assembly, 8 hour. Turn the dial on the timer clockwise to advance it into and out of defrost.)

This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

Clip-on bimetal defrost thermostat with leads (defrost thermostat assembly, clip-on)

This part acts as a safety device against over-heating in case of mechanical failure.

Light socket kit

The bulb is sold separately.

Compression nut (nut, 1/4" plastic water line)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Hinge bracket (door stop bracket)

This part is used to support the hinge.

Door hinge nylon washer (washer, door hinge)

Screw

Sold individually.

Hinge washer (door hinge washer/spacer)

The hinge washer works in conjunction with the door hinge on the refrigerator door. This part is white in color and measures approximately 0.75” in diameter. If the refrigerator door is making noise opening and closing, you may need to replace this part. This is a genuine OEM part and is sold individually.

Inlet hose washer (gasket, water inlet hose)

The high-pressure inlet hose washer is black in color. It is one inch in diameter, made of rubber, and used with many washing machines, refrigerators, and dishwashers. The washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged and will need to be replaced. This is a genuine OEM part and is sold individually.

Heater, defrost (defrost heater assembly)

The defrost heater is similar to the burners on an electric stove. It's located just beneath the cooling coils, which are concealed behind a panel in the freezer compartment. The heater gets hot. And, because it's close to the cooling coils, any ice or frost build-up melts.

Ice stripper (ice stripper for icemaker)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.