10650045710 Kenmore Refrigerator Parts List

Floating baffle (refrigerator auger shaft baffle)

This ice auger support, also known as a baffle, is a manufacturer-approved replacement part for your refrigerator ice maker. This part can become cracked or damaged, preventing your ice auger from doing its job. This repair requires extensive disassembly; take photos as you go to make reassembly easier. To replace this part, life the ice door out of the way and life the ice arm into the off position. Pull out the ice bucket and use a 1/4 inch nut driver to remove the screws holding the ice container and connecting rod in place. Pry the e-clip and washer off the bottom of the auger assembly. Use a 9/16ths wrench to remove the nut at the bottom of the auger. Pull off the auger teeth assembly and replace the auger support with your new part. Now you can begin reassembling.

Wire shelf (refrigerator freezer wire shelf)

This wire freezer shelf fits in the freezer to provide storage space. It is made of white metal, measures approximately 14 inches wide by 12 inches deep, and fits into the side freezer glides for easy adjusting. While these shelves are strong, they can bend and break due to frequent and heavy use over time, and should be replaced if damaged.

Shelf support (refrigerator crisper drawer cover support post)

Sold individually.

Thimble top (refrigerator door hinge bushing)

For white, biscuit, black and stainless models.

Screw (refrigerator screw)

Sold individually.

Water inlet valve (refrigerator water inlet valve)

This part releases water from the supply line when it's activated.

Ice dispenser motor coupling (refrigerator auger motor coupler)

This part attaches to the drive shaft of the ice dispenser motor.

Fan grommet (refrigerator door hinge bushing)

Sold Individually - Appliance originally takes 2.

Refrigerator compressor start relay

This compressor start relay is for refrigerators. The compressor start relay attaches to the compressor and helps start the compressor motor. Safely store any food that could deteriorate while the power is off and unplug the refrigerator before installing this part.

Bin-cntlvr (refrigerator door bin)

Evaporator fan motor (refrigerator evaporator fan motor)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Bottom kickplate clip (refrigerator toe grille clip)

This clip is sold individually.

Heater, defrost (refrigerator defrost heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Crisper drawer cover frame (refrigerator crisper drawer cover frame)

Soleniod assembly (refrigerator ice dispenser solenoid)

This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.