10650444900 Kenmore Refrigerator Parts List

Ice maker cover bracket (bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Fan grommet (grommet)

Sold Individually - Appliance originally takes 2.

Evaporator fan motor (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Heater, defrost (heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Condenser fan motor (motor-cond)

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fan motor has 3 terminals please order part number W10204250, otherwise order this part (WP2188874).

Screw

This screw is sold individually.

Touch-up paint - black (tuchup)

16ml

Socket

This light socket is a genuine OEM part for your refrigerator. The light socket powers the bulb that lights your fridge. To repair this part, you will need to remove the screws holding the control panel in place. Pull the panel out and unplug any terminals or wires connected to the socket. Plug the new socket into place, and reattach terminals and wires.

Touch-up paint - biscuit (tuchup)

Light cover lens (light lens)

Rear compressor cover (cover unit)

Used to cover up the compressor components.

Washer

Kickplate grille - black (grille)

This kickplate grille is attached to the bottom of the refrigerator.

Ice maker front cover (cover)