Parts for Kenmore Models 10651593010

Door shelf (trim)

This authentic Whirlpool refrigerator part is a door shelf rail. It snaps into your refrigerator door and prevents items from sliding or falling out when your open the door. It is made of plastic and is approximately 17 inches in length by 5 inches in width. To replace this part, simply snap out the old door shelf rail and install the new one.

Easy Part #:: EAP11740306

Availability:: In Stock

Price:: $43.12

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Easy Part #:: EAP347819

Availability:: In Stock

Price:: $18.90

Screw

This screw is sold individually.

Easy Part #:: EAP11742755

Availability:: In Stock

Price:: $12.18

Flipper

This part is a replacement flipper or emitter cover for your refrigerator. It is made of white plastic and is approximately 3 inches by 2 inches. The flipper shields the emitter control board and houses the flipper cover for the emitter board. If your flipper is broken or missing, your ice maker may not make or dispense ice, and will need to be replaced. This part is sold individually and is an authentic OEM part sourced directly from the manufacturer.

Easy Part #:: EAP11739242

Availability:: In Stock

Price:: $32.67

Wire shelf (shelf wire)

This wire freezer shelf fits in the freezer to provide storage space. It is made of white metal, measures approximately 14 inches wide by 12 inches deep, and fits into the side freezer glides for easy adjusting. While these shelves are strong, they can bend and break due to frequent and heavy use over time, and should be replaced if damaged.

Easy Part #:: EAP11752742

Availability:: In Stock

Price:: $48.44

Fresh food door gasket - black (gasket panel)

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Easy Part #:: EAP323906

Availability:: In Stock

Price:: $203.69

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Easy Part #:: EAP11743313

Availability:: In Stock

Price:: $53.34

Door light switch (light switch)

The white door light switch is in the control panel section of your refrigerator. The light will turn on when you open the door. If the light doesn?t turn on when the door is open the contacts in the switch could be burnt out and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Easy Part #:: EAP11738900

Availability:: In Stock

Price:: $26.83

Fresh food door gasket (gasket panel)

This door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Easy Part #:: EAP323900

Availability:: In Stock

Price:: $186.28

Shelf support (stud assembly)

Sold individually.

Easy Part #:: EAP12578346

Availability:: In Stock

Price:: $13.11

Screw

Sold individually.

Easy Part #:: EAP11742754

Availability:: In Stock

Price:: $7.37

Levers retainer/clip (clip)

This part is the replacement dispenser lever retainer for your refrigerator. It is made of metal and is approximately 2 inches long and ½ an inch wide. The bottom half of the dispenser lever retainer holds in the pivot points of the ice and water arms. If it breaks, the arms will be loose and can shake around. The top half springs the ice and water arms back into the original position, and if the retainer is broken, they will not be able to do this. The dispenser lever retainer is found behind the dispenser trim and can be removed with a ¼ inch nut driver. This part is sold individually and is an OEM part.