10655422501 Kenmore Refrigerator Parts List

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Water dispenser fitting and tube assembly (fitting)

Anti drip valve NOT included.

Grille

This is a kickplate, but you may also know it as a grate or a grille. It is a part for your refrigerator. The purpose of the kickplate is to allow air to circulate by flowing through the grates and into the machine compartment. This circulation of air is necessary because it will then cool the condenser. Black in color.

Water filter cap (filter cap)

The water filter cap fits onto the end of the water filter to cover the end and hold the filter in place.

Ice dispenser arm - white (arm dispenser)

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.

Rear roller (cabinet roller)

Sold Individually.

Wire shelf (shelf wire)

Sold individually.

Heater, defrost (heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Dispenser door pin (door hinge pin)

This dispenser door pin comes with the washer.

Condenser fan motor (motor-cond)

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Please note: If the original fan motor has 3 terminals please order part number W10204250, otherwise order this part (WP2188874).

Soleniod assembly (solenoid)

This part consists of a cube and arm that upon activation opens the ice container gate and allows the ice cubes to enter into the chute and into the ice and water dispenser.

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Water dispenser lever - white (arm dispenser)

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.

Touch-up paint - black (tuchup)

16ml

Touch-up paint - biscuit (tuchup)