Hello!
You're visiting the Easy Appliance Parts site in U.S.
Would you like to shop on the Canadian site?
This screw is sold individually.
This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.
This part attaches to the drive shaft of the ice dispenser motor.
This part includes 2 shelf support studs.
This door gasket is used to make an air-tight seal for the cabinet when the door is closed.
Sold Individually - 2 screws needed to mount each handle.
Sold individually.
Sold Individually - Appliance originally takes 2.
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver water when activated.
Both bottom door hinges are included in this set.
Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.
This clip is sold individually.
This dispenser door pin comes with the washer.
The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.