10657532792 Kenmore Refrigerator Parts List

Ice dispenser arm - white (arm dispenser)

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice when activated.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Dispenser door pin (door hinge pin)

This dispenser door pin comes with the washer.

Heater, defrost (heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Wire shelf (shelf wire)

Sold individually.

Rear roller (cabinet roller)

Sold Individually.

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Door shelf trim (door trim)

This door trim is located on the inside of the fridge/freezer door. It is held in with two end caps, and is used to store items in the door.

Touch-up paint - black (tuchup)

16ml

Coupling

Rear compressor cover (cover unit)

Used to cover up the compressor components.

Strain relief (clip)

Sold individually.

Endcap - left side (endcap)

Ice maker front cover (cover)