10657702702 Kenmore Refrigerator Parts List

Single shelf stud (shelf stud)

This part screws into the side of the wall in your fresh food compartment and supports a shelf.

Screw

Sold individually.

Water filter cap - gray (filter cap)

This is a replacement water filter cap for your refrigerator. The cap is made of gray plastic and is approximately 2.5 inches in diameter. It is sold individually. The water filter cap protects and secures the water filter on the bottom of the refrigerator. If it is cracked, broken, or missing, this is the part that replaces it. To complete this repair, simply remove and discard the damaged cap, and replace it with the new one. This is an OEM part sourced directly from the manufacturer.

Roller and eyelet - kit of 2 (roller)

Coupling

This coupling is used for indoor ice dispensers.

Freezer door gasket - black (gasket panel)

This door gasket is used to seal the freezer door when closed.

Top hinge - right side (door hinge)

This part is the top hinge for your refrigerator door. It is made of metal and is approximately 5 inches by 3 ¼ inches in size. This hinge is for the right side of the refrigerator door only. The left side hinge is sold separately. The top hinge allows your refrigerator door to open and close properly. If your door is hanging strangely, or if the door won’t open or close properly, you may need to replace the top hinge. This part is sold individually and is an authentic OEM part.

Light socket kit (light socket)

The bulb is sold separately.

Refrigerator front roller kit (cabinet roller)

Support wheel assembly with bracket. Kit of 2.

Installation screw (screw)

This screw is sold individually.

Washer, coupling (washer)

This washer is sold individually.

Freezer door gasket - white (gasket panel)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Screw

Sold individually.

Ice maker cover bracket (bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.