10657782703 Kenmore Refrigerator Parts List

Freezer door gasket - white (gasket panel)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Ice maker cover bracket (bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Fan grommet (grommet)

Sold Individually - Appliance originally takes 2.

Ice dispenser door motor (motor)

This part shuts and opens the ice door on the ice dispenser chute.

Evaporator fan motor (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Thermistor

This part is used to detect the temperature in the air inside of your refrigerator.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Heater, defrost (heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Screw

This screw is sold individually.

Water inlet valve (inlet valve)

This part releases water from the supply line when it's activated.

Touch-up paint - black (tuchup)

16ml

Egg container (egg bin)

This part is used to hold eggs.

Touch-up paint - biscuit (tuchup)

Light cover lens (light lens)