10658029802 Kenmore Refrigerator Parts List

Search the entire 10658029802 by part description. Keep descriptions simple, e.g. "belt" or "pump". Need help?

Refrigerator front roller kit (cabinet roller)

Support wheel assembly with bracket. Kit of 2.

Easy Part #:
EAP370711
Availability:
In Stock
Price:
$76.11

Relay and overload combination (start-dev)

This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against excessive temperatures.

Easy Part #:
EAP11749877
Availability:
In Stock
Price:
$65.17

Ice bucket auger motor (motor)

This auger motor is for refrigerators. Auger motor turns the auger that pushes the ice cubes through the dispenser chute. Safely store any food that could deteriorate while the power is off. Unplug the refrigerator before installing this part. Wear work gloves to protect your hands.

Easy Part #:
EAP11723175
Availability:
In Stock
Price:
$104.76

Installation screw (screw)

This screw is sold individually.

Easy Part #:
EAP11741512
Availability:
In Stock
Price:
$7.23

Washer, coupling (washer)

This washer is sold individually.

Easy Part #:
EAP11739247
Availability:
In Stock
Price:
$8.78

Freezer door gasket - white (gasket panel)

This door gasket is used to make an air-tight seal for the cabinet when the door is closed.

Easy Part #:
EAP323899
Availability:
In Stock
Price:
$199.34

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Easy Part #:
EAP11756735
Availability:
In Stock
Price:
$59.38

Ice maker cover bracket (bracket)

This is the replacement ice maker cover bracket for your refrigerator. It is made of white plastic and is approximately 5 inches wide and 2 inches long. The ice maker cover bracket holds and supports the ice maker cover. If the ice maker cover is loose or missing, you may need to replace the bracket. You will also want to replace the bracket if it will not stay in place, or if it is cracked or broken. To replace the cover bracket, simply remove the ice maker cover, then use a ¼ inch nut driver to loosen and remove the bracket. Screw in the new bracket and replace the cover to complete your repair. This is an OEM part that is sold individually.

Easy Part #:
EAP11739245
Availability:
In Stock
Price:
$7.40

Fan grommet (grommet)

Sold Individually - Appliance originally takes 2.

Easy Part #:
EAP11739011
Availability:
In Stock
Price:
$9.38

Electronic defrost control board with wire harness and screws (defrost timer)

This part is located in the control box in the refrigerator.

Easy Part #:
EAP372261
Availability:
In Stock
Price:
$171.32

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Easy Part #:
EAP11738914
Availability:
In Stock
Price:
$10.33

Water dispenser fitting and tube assembly (fitting)

Anti drip valve NOT included.

Easy Part #:
EAP886371
Availability:
In Stock
Price:
$67.23

Rear roller (roller)

Sold Individually.

Easy Part #:
EAP11751112
Availability:
In Stock
Price:
$29.43

Heater, defrost (heater)

The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.

Easy Part #:
EAP11740459
Availability:
In Stock
Price:
$47.43

Dispenser door pin (door hinge pin)

This dispenser door pin comes with the washer.

Easy Part #:
EAP11739225
Availability:
On Order
Price:
$10.52