10670234900 Kenmore Refrigerator Parts List

Ice mold

This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.

Refrigerator shelf end cap - white (endcap)

Sold individually.

Icemaker motor kit (motor mold)

This kit includes the module motor, ejector arm, and ice stripper arm. The complete icemaker is sold separately.

Water tube kit (water tube)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Refrigerator door gasket - beige (gasket panel)

This misty beige door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Ice pan

This part may come in white or clear plastic, but either will still work and fit properly in your appliance.

Screw

Sold individually.

Screw

Sold Individually.

Light socket kit (light socket)

The bulb is sold separately.

Hinge bracket (door bracket)

This part is used to support the hinge.

Front roller (cabinet roller)

Sold individually. Hardware not included. Roller only.

Door hinge nylon washer (washer)

Insert (washer)