106708764 Kenmore Refrigerator Parts List

Crisper drawer support - cut-to-fit (crisper support)

This part may be longer than the original - it might need to be cut to the correct size for your appliance.

Sheet metal screw (flat head sheet metal screw)

Sold individually.

Cold control thermostat (thermostat, refrigerator. Note: Poor cooling problems are normally not the result of a thermostat problem.)

The cold control thermostat helps maintain the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process. If the refrigerator is too warm you may need to replace the control thermostat. This part has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Ice pan (ice bucket)

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Hinge sleeve hole plug - white (hinge sleeve hole plug, white)

Sold individually.

Screw (screw no. 8 x 1/2)

Sold Individually.

Hinge washer (washer, door hinge, 11/64")

This part can be used on either side of the center door hinges for some refrigerators.

Screw - 8-18 x 1/2 (screw)

Sold individually.

Door hinge (center door hinge)

Sold individually.

Screw

Sold individually.

Shelf stud/support (stud-shelf)

Sold individually.

Freezer door gasket

This misty beige door gasket is used to seal the freezer door when closed to keep the cool air inside and the room air out.

Screw (screw 8-18 x 1/2)

This screw is sold individually.

Evaporator/drain pan (defrost drain pan)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.