106721570 Kenmore Refrigerator Parts List

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Hex nut (nut & lockwasher assy-use w/531594 motor)

This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.

Plastic tubing inserts - 4 included (insert, plastic tube)

These inserts are used with 1/4 inch plastic tubing.

Speed nut (nut, speed)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Door gasket (gasket, magnetic)

This door gasket is used to seal the freezer door when closed.

Water hose clamp (clamp)

These tube clamps are sold individually. The screw is not included.

Thermostat kit (thermostat & barrier assembly)

Evaporator/drain pan (tray, evaporator)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

Screw

This screw is sold individually.

Screw - 8-32 x 1-1/4 (screw)

Sold individually.

Condenser fan blade (blade, fan)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Transformer screw (screw)

This screw is sold individually.

Spacer (spacer, holding switch)

Ice maker drive gear (gear)

The drive gear works in conjunction with the ejector blades in your ice maker. The drive gear attaches to the cam to help rotate the ejector arm to push the ice from the ice maker into the ice container. If the ice maker isn’t dispensing ice you may need to replace this part. The drive gear is approximately 1 1/2” in diameter, white in color and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.

Bimetl-def (defrost, bi-metal)