10672972901 Kenmore Refrigerator Parts List

Door shelf wide trim (door trim)

This part is the replacement door shelf wide trim for your refrigerator. It is made of white plastic and is approximately 22 inches long and 2 inches wide. The shelf trim snaps into an end bracket at either end, and these end brackets attach it to the refrigerator door. The trim then can hold items on the door shelf in place. If your trim is broken, simply lift the tab on the inside of the end bracket and remove the trim. Snap the new trim into the end brackets to complete the repair. This item is sold individually and is a genuine OEM part.

Icemaker motor kit (motor mold)

This kit includes the module motor, ejector arm, and ice stripper arm. The complete icemaker is sold separately.

Water tube kit (water tube)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Screw

Sold individually.

Door shelf trim - narrow (door trim)

This door shelf trim snaps into place on the door to hold items on the door shelf. This genuine OEM door shelf trim is approximately 22 inches long and made of white plastic.

Light socket kit (light socket)

The bulb is sold separately.

Compression nut (nut-compre)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Hinge bracket (door bracket)

This part is used to support the hinge.

Shelf glass insert (shelf glass)

Glass shelf insert for a refrigerator bin.

Door hinge nylon washer (washer)

Insert (washer)

Evaporator fan motor (motor evaporator)

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

Wire shelf (shelf wire)

Sold individually.

Heater, defrost (heater)

The defrost heater is similar to the burners on an electric stove. It's located just beneath the cooling coils, which are concealed behind a panel in the freezer compartment. The heater gets hot. And, because it's close to the cooling coils, any ice or frost build-up melts.