1067640210 Kenmore Refrigerator Parts List

Screw (screw, 8 x 5/8)

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Freezer door gasket (gasket, door freezer)

This white door gasket is used to seal the freezer door when closed.

Hex nut (nut used with 531594 motor)

This hex nut will work with a variety of appliances. This part is made of metal and measures 8-32 x .124. Over time the hex nut will wear out and will need to be replaced and is recommended to order a spare. This is a genuine OEM part and sold individually.

Speed nut (nut, speed 1/4-20)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Evaporator/drain pan (tray, evaporating)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

Screw

This screw is sold individually.

Screw - 8-32 x 1-1/4 (screw, 8 x 13/16)

Sold individually.

Transformer screw (screw, 8-18 x 1/2)

This screw is sold individually.

Condenser fan blade (blade, fan)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Bimetl-def (defrost, bimetal)

Door hinge cover (cover, hinge)

Compressor start relay (used on compressor 463877)

The compressor start relay attaches to the compressor and helps start the compressor motor and then shuts off as soon as the motor gets up to speed. This part is black in color and measures approximately 1”. The overload is not included, it must be ordered separately. Please remember to disconnect the power before starting your repair. This is a genuine OEM part.

Filter drier tube (drier)

The filter drier tube with system access port, works in conjunction with your refrigerator by filtering the refrigerant that travels through the seal system of your refrigerator. This part measures approximately 10” long and is a genuine OEM part. Please make sure to disconnect the power before starting the repair. Please note it is recommended to have a service technician install the filter drier tube because it involves recharging and recovering refrigerant in the sealed refrigerant system.

Stud-shelf (stud, shelf)

Clip (clip, air duct)