1068139520 Kenmore Refrigerator Parts List

Plastic tubing inserts - 4 included (insert tube)

These inserts are used with 1/4 inch plastic tubing.

Speed nut (speednut 1/4-20)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Hinge sleeve hole plug - white (white)

Sold individually.

Water hose clamp (clamp tube)

These tube clamps are sold individually. The screw is not included.

Screw (screw 8x1/2)

Sold Individually.

Hinge washer (washer 11/64)

This part can be used on either side of the center door hinges for some refrigerators.

Compressor relay/overload kit (overload)

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overload provides extra protection for the compressor motor.

Screw cover

For the bottom of refrigerator door handle - for Platinum model only.

Evaporator/drain pan (tray evaporating)

This tray is used to collect the access water from the cooling system to prevent water from leaking on to your floor.

Door hinge (hinge & shim center)

Sold individually.

Crisper shelf support stud - white (stud shelf)

Sold Individually.

Condenser fan blade (fan)

This fan blade circulates air over the condenser. It mounts onto the shaft of the condenser fan motor.

Transformer screw (screw 8-18x1/2)

This screw is sold individually.

Spacer (spacer holding switch)

Ice maker drive gear (gear)

The drive gear works in conjunction with the ejector blades in your ice maker. The drive gear attaches to the cam to help rotate the ejector arm to push the ice from the ice maker into the ice container. If the ice maker isn’t dispensing ice you may need to replace this part. The drive gear is approximately 1 1/2” in diameter, white in color and made of plastic. Please remember to disconnect the power and water supply before starting your repair. This is a genuine OEM part.