1068370760 Kenmore Refrigerator Parts List

Hinge bracket (bracket, door stop)

This part is used to support the hinge.

Refrigerator front roller kit (roller, front)

Support wheel assembly with bracket. Kit of 2.

Door shelf end cap (end cap, trim (2))

This white door shelf end cap is used on either the fridge or freezer section depending upon your model number. It can be used on both the left and right hand sides.

Evaporator drip tray (tray, evaporator)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Screw (screw, 10-32 x 23/32)

Sold individually.

Kickplate support clip (support (2))

Sold individually.

Rear roller (roller, rear (2))

Sold Individually.

Single hex head screw (screw, 8 x 1/2 (2))

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Freezer door gasket (door gasket magnetic)

This white door gasket is used to seal the freezer door when closed.

Shelf support kit (saddle stud, r.S.)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Crisper drawer support - cut-to-fit (crisper, support)

This part may be longer than the original - it might need to be cut to the correct size for your appliance.

Screw (screw (oversized))

This screw is sold individually.

Water inlet hose washer (washer)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Icemaker drive gear (gear)

Start relay combination (relay)

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.