1068490286 Kenmore Refrigerator Parts List

Kickplate grille (grille)

This kickplate grille is attached to the bottom of the refrigerator.

Evaporator drip tray (tray)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Bottom kickplate clip (clip, grille)

This clip is sold individually.

Rear roller (cabinet roller)

Sold Individually.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Shelf support kit (shelf stud)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Touch-up paint - black (tuchup)

16ml

Crisper cover (pan cover)

Freezer door gasket (door gasket)

This white door gasket is used to seal the freezer door when closed.

Start relay combination (start relay)

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

Compressor relay and overload kit (overload)

The overload protects a motor from overheating and the relay boosts the compressor.

Air diffuser assembly (diffuser)

This air diffuser controls the amount of cold air distributed through the refrigerator.

Grommet (service) (grommet)

Speed nut (nut)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Door shelf bin (shelf trim)

Sold individually.