1068516914 Kenmore Refrigerator Parts List

Water tube kit (tub water)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Evaporator fan motor kit (fan, motor)

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

Arm-shut (shut off arm)

Cycling thermostat (thermostat (also order 542639 cement alumilastic))

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Door shelf end cap (support, trim end)

Sold individually.

Light socket kit (socket assembly)

The bulb is sold separately.

Compression nut (nut)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Refrigerator front roller kit (roller, front)

Support wheel assembly with bracket. Kit of 2.

Water dispenser reservoir tubing (water reservoir)

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.

Ice dispenser motor coupling (coupling, motor)

This part attaches to the drive shaft of the ice dispenser motor.

Screw

Sold individually.

Kickplate support clip (grille, support)

Sold individually.

Rear roller (roller assembly (rear))

Sold Individually.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Ice stripper (ice striper)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.