1068562383 Kenmore Refrigerator Parts List

Arm-shut (shut off arm)

Cycling thermostat (thermostat (also order 542639 cement alumilastic))

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Door shelf end cap (support, door trim)

Sold individually.

Light socket kit (socket, light)

The bulb is sold separately.

Compression nut (nut, compression)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Refrigerator front roller kit (roller, front)

Support wheel assembly with bracket. Kit of 2.

Ice dispenser motor coupling (coupling, motor)

This part attaches to the drive shaft of the ice dispenser motor.

Screw

Sold individually.

Fresh food door gasket (gasket, refrigerator door)

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Kickplate support clip (grille, support)

Sold individually.

Rear roller (roller assembly (rear))

Sold Individually.

Door shelf end cap (retainer, shelf trim)

This piece of end cap trim can be used for either the refrigerator door shelf or the freezer door shelf.

Door shelf end cap (retainer, shelf trim)

Sold individually.

Single hex head screw (screw)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Ice stripper (ice striper)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.