1068562783 Kenmore Refrigerator Parts List

Evaporator fan motor kit (motor evaporator)

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

Arm-shut

Spray paint - 12 oz. - white (spray)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Cycling thermostat (thermostat)

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Door shelf end cap (cap)

Sold individually.

Light socket kit (light socket)

The bulb is sold separately.

Compression nut (nut-compre)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Refrigerator front roller kit (cabinet roller)

Support wheel assembly with bracket. Kit of 2.

Water dispenser reservoir tubing (reservoir)

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.

Ice dispenser motor coupling (coupling)

This part attaches to the drive shaft of the ice dispenser motor.

Screw

Sold individually.

Fresh food door gasket (door gasket)

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Kickplate support clip (support)

Sold individually.

Rear roller (cabinet roller)

Sold Individually.

Door shelf end cap (endcap trim)

This piece of end cap trim can be used for either the refrigerator door shelf or the freezer door shelf.