1068566713 Kenmore Refrigerator Parts List

Ice stripper (strips arm)

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold. Once removed from the mold, the ice pieces are then deposited into the ice bucket ready to be dispensed. If your ice maker is not making any ice you may need to replace this part. The part is white in color and is approximately 9-inch long. The ice stripper is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Screw

This screw is sold individually.

Water inlet hose washer (4-pack of hose washers)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Touch-up paint - black (tuchup)

16ml

Fresh food door gasket (door gasket)

This white door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Dispenser overflow grille - black only (grille)

NOTE: As per manufacture this dispenser overflow is only available in black. Chrome is NOT available.

Coupling

Light switch

This part turns the light on/off as the door opens and closes.

Screw

Sold individually.

Water dispenser arm (lever)

Once a glass is pressed against the actuator pad it will cause the dispenser to deliver ice or water when activated.

Plastic tubing inserts - 4 included (insert)

These inserts are used with 1/4 inch plastic tubing.

Grommet (service) (grommet)

Speed nut (nut)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Touch-up paint - almond (tuchup)

Water hose clamp (clamp)

These tube clamps are sold individually. The screw is not included.