1068590210 Kenmore Refrigerator Parts List

Screw

This screw is sold individually.

Water inlet hose washer (4-pack of hose washers)

The washer is black in color and works in conjunction with the fill hose in your washer. This washer helps by creating a watertight seal to avoid leaking. Over time the washer may be worn down or damaged which will allow water to pass through and start leaking and will need to be replaced. This part measures 1-1/16” x 5/8” and is made of rubber. This is a genuine OEM part and is sold individually.

Touch-up paint - black (tuchup)

16ml

Crisper cover (pan cover)

Freezer door gasket (door gasket)

This white door gasket is used to seal the freezer door when closed.

Start relay combination (start relay)

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

Compressor relay and overload kit (overload)

The overload protects a motor from overheating and the relay boosts the compressor.

Plastic tubing inserts - 4 included (insert)

These inserts are used with 1/4 inch plastic tubing.

Light bulb - 40w (light bulb)

This light bulb is found behind the controls box in some refrigerators.

Ice pan

Shut off arm (arm)

The shut off arm works in conjunction with the ice maker in your refrigerator. When the shut off arm is high enough the ice maker will shut off and no more ice will be produced until the level of ice in the bin drops. The ice maker can be turned off by lifting the arm all the way to the top until in a locked position. This part is made of metal, and measures approximately 9 inches wide and 4 inches in height.

Air diffuser assembly (diffuser)

This air diffuser controls the amount of cold air distributed through the refrigerator.

Grommet (service) (grommet)

Speed nut (nut)

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Door shelf bin (shelf trim)

Sold individually.