1068592661 Kenmore Refrigerator Parts List

Water fill cup and bearing (bearing & inlet)

The ice maker fill cup and bearing dispenses the water into the ice mold during the fill cycle. If your ice maker is not making ice, is leaking, or the cup or bearing is cracked, you will need to replace this part. This part is three inches long, white in color, and is made of plastic. It is a genuine OEM part. Please remember to disconnect the power and water supply to your refrigerator before starting the repair.

Ice mold (mold & heater assembly (also order 542638 silicone grease))

This ice cube mold and heater assembly has a flake resistant surface with separations that mold eight ice crescents and is used with modular style icemakers on some refrigerators. The mold heater is an electrical device that thaws the ice quickly, so it can be released from the icemaker mold. If your ice maker is not making ice you may need to replace this part. Please remember to disconnect the power and water supply before starting your repair.

Screw

Metallic screw that is less than an inch long. Does not include the plastic washer.

Water tube kit (tube, water)

The water tubing is made of plastic and goes between the water valve and the back of your refrigerator. The tubing is 72-inch in length, 1/4 inch in diameter, and comes with 2 inserts. This tube may be longer than the original tube and may need to be cut to fit your appliance. The water tube transports water to the ice and water dispensers. If there is no water going to the ice maker, your refrigerator is leaking, or if the ice and water dispensers are not dispensing properly, you may need to replace this tube kit. This part is an OEM part directly from the manufacturer. Please remember to shut off the water supply and to disconnect the power to your refrigerator before starting your repair.

Evaporator fan motor kit (fan motor)

This refrigerator evaporator fan motor kit comes with a wiring harness and a four-inch push on fan blade.

Arm-shut (shut off arm)

Cycling thermostat (thermostat (also order 542369 cement alumilastic))

The ice maker thermostat, also known as bi-metal device, regulates and controls the activation of the icemaker ejection cycle. The thermostat lets the ice maker know when it is cold enough to produce ice. If your ice maker is not making ice or not dispensing ice, you may need to replace the thermostat. This is a genuine OEM part and comes with two retaining clips. Please remember to disconnect power to your refrigerator before starting your repair.

Door light switch (light switch)

The white door light switch is in the control panel section of your refrigerator. The light will turn on when you open the door. If the light doesn?t turn on when the door is open the contacts in the switch could be burnt out and will need to be replaced. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting your repair.

Screw

Sold individually.

Shelf support stud (stud, front (2))

This part screws into the side of the wall in your fresh food compartment and supports a shelf.

Light socket kit (socket, light)

The bulb is sold separately.

Compression nut (nut, compression)

This single 1/4-inch compression nut is used to connect the lines that supply water to the correct components, the water dispenser and the ice maker, with the plastic water line of the icemaker assembly. This is a genuine OEM part. Please remember to disconnect the power and water supply to the refrigerator before starting your repair.

Shelf support stud (support, stud (20))

Sold individually. This part screws into the side of the wall in your fresh food compartment and supports a shelf.

Refrigerator front roller kit (front roller (2))

Support wheel assembly with bracket. Kit of 2.

Water dispenser reservoir tubing (water reservoir)

This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.