1068650681 Kenmore Refrigerator Parts List

Kickplate grille (grille)

This kickplate grille is attached to the bottom of the refrigerator.

Evaporator drip tray (tray, evaporator)

This is the replacement evaporator drip tray for your refrigerator. It is made of white plastic and is approximately 19 inches by 9 inches. The evaporator drip tray sits below the evaporator to collect dripping water. If the drip tray is damaged, you may notice that your refrigerator is leaking. Because it is made of plastic, the drip tray can eventually develop a crack. You will need to pull out the refrigerator from the wall, and take off the bottom panel on the back of your refrigerator in order to access the drip tray for replacement. This is an OEM part sourced directly from the manufacturer.

Bottom kickplate clip (clip, grille retainer (2))

This clip is sold individually.

Crisper drawer shelf frame - glass not included (crisper cover)

This is the frame only. The glass is sold separately.

Single hex head screw (screw, 7 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Freezer door gasket (door gasket, magnetic)

This white door gasket is used to seal the freezer door when closed.

Shelf support kit (saddle stud, r.S.)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Crisper drawer support - cut-to-fit (crisper, support)

This part may be longer than the original - it might need to be cut to the correct size for your appliance.

Start relay combination (relay)

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

Compressor relay and overload kit (overload/relay assembly)

The overload protects a motor from overheating and the relay boosts the compressor.

Sheet metal screw (screw, 8 x 5/8)

Sold individually.

Cold control thermostat (thermostat assembly)

The cold control thermostat helps maintain the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process. If the refrigerator is too warm you may need to replace the control thermostat. This part has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Door handle spacer (spacer, handle door (2))

Sold individually.

Side hinge plate (hinge pin, center)

Grommet (service) (grommet)