1068752681 Kenmore Refrigerator Parts List

Freezer door gasket (door gasket magnetic)

This white door gasket is used to seal the freezer door when closed.

Shelf support kit (saddle stud, r.S.)

This kit is enough for one right and one left support. There are 2 different styles of supports in this kit.

Crisper drawer support - cut-to-fit (crisper, support)

This part may be longer than the original - it might need to be cut to the correct size for your appliance.

Start relay combination (relay)

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

Sheet metal screw (screw, 8 x 5/8)

Sold individually.

Ice maker front cover (cover)

Cold control thermostat (thermostat assembly)

The cold control thermostat helps maintain the proper temperature. When the refrigerator reaches the desired temperature, this part interrupts the flow of electricity to the compressor which stops the cooling process. If the refrigerator is too warm you may need to replace the control thermostat. This part has a temperature range from 29.5 degrees Fahrenheit to 16.5 degrees Fahrenheit and a capillary length of 35 inches. This is a genuine OEM part. Please remember to disconnect the power to your refrigerator before starting the repair.

Door handle spacer (spacer, handle door (2))

Sold individually.

Screw

Sold individually.

Plastic tubing inserts - 4 included (insert, tube)

These inserts are used with 1/4 inch plastic tubing.

Shut off arm

The shut off arm works in conjunction with the ice maker in your refrigerator. When the shut off arm is high enough the ice maker will shut off and no more ice will be produced until the level of ice in the bin drops. The ice maker can be turned off by lifting the arm all the way to the top until in a locked position. This part is made of metal, and measures approximately 9 inches wide and 4 inches in height.

Side hinge plate (hinge pin, center)

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Glass shelf (glass, crisper cover)

Glass ONLY.

Hinge sleeve hole plug - white (white)

Sold individually.