1069702610 Kenmore Refrigerator Parts List

Plastic tubing inserts - 4 included (insert, tube)

These inserts are used with 1/4 inch plastic tubing.

Ice pan (ice cube pan)

Shut off arm

The shut off arm works in conjunction with the ice maker in your refrigerator. When the shut off arm is high enough the ice maker will shut off and no more ice will be produced until the level of ice in the bin drops. The ice maker can be turned off by lifting the arm all the way to the top until in a locked position. This part is made of metal, and measures approximately 9 inches wide and 4 inches in height.

Side hinge plate (hinge pin, center)

Speed nut

The speed nut works in conjunction with the condenser fan motor. The fan blade attaches to the condenser motor shaft and the speed nut secures the blade to the motor. Make sure the speed nut is properly attached and secured. If the part is damaged, worn, or will not tighten, you will need to replace it. This part measures 1/4-20 inch. Sold individually. Please remember to disconnect the power to the refrigerator before starting your repair.

Glass shelf (glass, crisper cover)

Glass ONLY.

Hinge sleeve hole plug - white (white)

Sold individually.

Water hose clamp (clamp, tube)

These tube clamps are sold individually. The screw is not included.

Screw (screw, 8 x 1/2)

Sold Individually.

Hinge washer (washer, 11/64)

This part can be used on either side of the center door hinges for some refrigerators.

Ejector arm (ejector)

This arm is used to eject the ice from the icemaker into the bin.

Ice maker fill tube gasket (seal gasket)

Screw - 8-18 x 1/2 (screw (10))

Sold individually.

Ice maker wire harness (harness, wiring)

This wire harness has a flat connector.

Screw (screw, 8-32 x 27/64)

This screw is sold individually.