11076901690 Kenmore Dryer Parts List

Thermal cut-off fuse kit (high-limit thermostat. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermost)

Dryer door switch actuator spring/lever (dryer door/washer lid actuator spring steel for door switch)

This black actuator spring with white rubber tip is used for both dryer doors and washer lids.

Screw - 10-16 x 1 (screw)

This screw is sold individually.

Push-to-start switch - 2 terminal (dryer push-to-start switch, 2-terminal. If this switch is defective, the dryer will not start. To determine if the switch is defective, use a multimet)

This part is used to start the dryer once you have selected a setting on the timer.

Drum support shaft - rear shaft with right hand threads (rear,left hand thread shaft. Part is updated so nuts may need to be replaced as well on older dryers.)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Screw (screw with plastic washer 8-18 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Blower wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Cover screw (screw)

Sold individually.

Single access panel spring retainer/clip (access panel retaining spring clip)

Sold Individually.

Drive motor with threaded shaft - 120v 60hz (dryer drive motor. The drive motor drives the rotation of the dryer's drum. If the drive motor is defective, the dryer won't spin..)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Timer (dryer timer. The timer controls all of the functions of the dryer. If the timer is defective, the dryer may not start or may not advance through the d)

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

Drum support roller shaft - right hand threads (shaft for dryer drum support roller. Front shaft with right hand threads. Part is updated so nuts may need to be replaced as well on older dryers.)

This shaft is for the front with right hand thread. Sold individually.

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Single access panel clip (dryer access panel clip, one per package)

Sold individually.