110C87576601 Kenmore Dryer Parts List

Blower housing seal (seal, blower cover plate)

This part seals between the blower housing and the blower housing cover.

Spring (spring for idler pulley arm in dryer)

Single hex head screw (screw 1/4" hex head, 10-12 x 1/2)

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

Seal, outlet housing (outlet housing seal with adhesive strip)

Terminal block screw kit (screw and nut kit, electric dryer cord connector.)

This kit includes 3 screws and 3 nuts.

Stacking kit

This kit allows you to stack your washer and dryer to maximize your laundry space.

Clamp-motor (motor retaining clamp)

This clamp is used to secure the drive motor.

Side and bottom vent kit (side or bottom venting kit)

This kit is used for the bottom and side exhaust. The kit includes both the straight and elbow vent.

Electronic control board (main control board. Note: This part is often misdiagnosed. Please enter your dryer model# in our repair help section for additonal repair help.)

This part is located in the control panel. It senses the resistance change and opens and closes a relay sending power to the dryer heater.

Moisture sensor wire harness (harness, sensor)

Lens (light lens cover)

This parts covers the bulb inside the drum.

Rack dry (drying rack designed for Whirlpool 27 inch dryers with lint screens located inside the front door opening)

Door switch and actuator kit (appliance switch kit. Often used as dryer door switch or broken drum belt switch.)

This part recognizes whether the door is open or closed.

Washer, thrust (thrust washer)

Strike-door (door strike)