110C96562500 Kenmore Dryer Parts List

Screw, 8/18 x 3/8 (screw, 10-24 3/8)

This screw is sold individually.

Dryer drum seal with adhesive (dryer drum felt seal kit. Includes silicone rubber adhesive.)

This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.

Touch-up paint - white (white touch-up paint)

This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, and freezers. This is a genuine OEM part and includes a brush applicator. Please remember to wear gloves to protect your hands when applying this paint.

Thermal cut-off fuse kit (high-limit thermostat. If the dryer overheats, the high-limit thermostat cuts off power to the dryer. If the dryer won't heat, the high-limit thermost)

Outlet screen door grille (outer grille)

Top cover for lint filter.

Screw - 10-16 x 1 (screw)

This screw is sold individually.

Drum support shaft - rear shaft with right hand threads (rear,left hand thread shaft. Part is updated so nuts may need to be replaced as well on older dryers.)

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Screw (screw with plastic washer 8-18 x 1/2)

Metallic screw that is less than an inch long. Does not include the plastic washer.

Blower wheel

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over time. But if it's noisy, it may simply be clogged with lint. Clean the blower and test to see if the dryer is still noisy. If it is, you probably need to replace it.

Cover screw (screw)

Sold individually.

Drive motor with threaded shaft - 120v 60hz (dryer drive motor. The drive motor drives the rotation of the dryer's drum. If the drive motor is defective, the dryer won't spin..)

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

Spray paint - 12 oz. - white (spray paint, white, 12 ounces)

Spray paint is designed to help cover up any scratches or chips on your appliances. This spray pant is white in color and comes in a 12 oz aerosol can. Please make sure to clean the area that requires touch up to avoid any old paint or dirt getting into the fresh paint. When using the spray paint it is recommended to wear gloves and a protective mask. Make sure to shake the can well before using and to spray a few inches away from the surface for best results. Please wait until the paint is dried before using the appliance. This is a genuine OEM part.

Lp gas con (dryer l.P conversion kit natural gas to lp (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.)

This gas conversion kit is used to convert natural gas burners to liquid propane in dryers. If your dryer will not start, heat, or there is an unusual smell, replacing this part can be a solution to the problem. The tools needed for this repair project are: a putty knife, 5/16 inch nut driver, small flathead screwdriver, pliers, and a 3/8 inch wrench. As a safety precaution remember to unplug your dryer from the power source before beginning this installation project. Refer to the manual provided by the manufacturer for further installation instructions and a detailed diagram.

Motor pulley

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumble, and may not start altogether. A damaged motor pulley can also damage the dryer belt, and it may need to be replaced as well. Be sure to disconnect power from the dryer before you begin this repair. This motor pulley is a genuine OEM part sourced directly from the manufacturer.

Dryer screw (screw, baffle mounting)

11-16 x 3/4 Sold individually.